ADTRAN Stub Routing Specifikace stáhnout pdf (Strana 526)

100

101

Line (Telnet) Interface Config Command Set Command Reference Guide

LINE (TELNET) INTERFACE CONFIG COMMAND SET

To activate the Line (Telnet) Interface Configuration command set, enter the line telnet command

specifying a Telnet session(s) at the Global Configuration Mode prompt. For example:

Router>

enable

Router#

configure terminal

Router(config)#

line telnet 0 4

Router(config-telnet0-4)#

You can select a single line by entering the line telnet command followed by the line number (0-4). For

example:

Router>

enable

Router#

configure terminal

Router(config)#

line telnet 2

Router(config-telnet2)#

The following commands are common to multiple command sets and are covered in a centralized section

of this guide. For more information, refer to the sections listed below:

do on page 558

end on page 559

exit on page 560

All other commands for this command set are described in this section in alphabetical order.

access-class <listname> in on page 527

line-timeout <minutes> on page 528

password <password> on page 531

1 2 ... 521 522 523 524 525 526 527 528 529 530 531 ... 567 568

Komentáře k této Příručce

Žádné komentáře

ADTRAN Stub Routing Specifikace Strana 526

Komentáře k této Příručce

Související produkty a manuály pro Sítě ADTRAN Stub Routing