ADTRAN TRACER 6000 SERIES Průvodce řešením problémů stáhnout pdf (Strana 97)

TRACER 6000 Series Integrated System Manual Section 6 DLP-3

4. From the MANAGEMENT/SNMP CONFIGURATION menu page, select the IP ADDRESS field and press

<Enter>. Type the IP address provided by your network manager and press <Enter> to accept the

change. Repeat the process for the S

UBNET MASK and DEFAULT GATEWAY options.

The TRACER 64x0 is now available for Telnet access. Complete the steps outlined in DLP-4, Verifying

Communications Over an IP LAN, on page 99.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 131 132

TRACER 6000 SERIES 1
Trademarks 2
To the Holder of the Manual 2
About this Manual 2
Revision History 3
Safety Instructions 4
FCC-Required Information 5
FCC Output Power Restrictions 6
Table of Contents 9
SYSTEM DESCRIPTION 11
1. SYSTEM OVERVIEW 12
2. FEATURES AND BENEFITS 12
Configuration and Management 12
Operational 12
Ω Interface 13
1. LINE-OF-SIGHT 16
Terminology 16
2. DECIBELS 16
4. RECEIVER POWER 17
Antenna Gain 18
G 10 log k 18
Transmitted Power (P 20
Carrier Wavelength (λ) 20
Path Distance (d) 21
System Losses (L) 21
Path Loss (L 22
5. RECEIVER SENSITIVITY 23
6. ANTENNA INFORMATION 24
Antenna Alignment 24
TRACER RSSI Test Points 24
Real-time Signal Values 24
Antenna Beam Patterns 25
7. OTHER CONSIDERATIONS 27
Path Availability 27
Terrain Factor (a) 28
Climate Factor (b) 28
ENGINEERING GUIDELINES 29
1. EQUIPMENT DIMENSIONS 30
2. POWER REQUIREMENTS 30
*TRACER 64x0 high 31
*TRACER 6420 (L1) only 31
AUX RS232 Interface (RJ-45) 32
CRAFT Port (DB-9) 33
5. NETWORK MODULE INTERFACES 37
4xT1 Module 37
Quad Ethernet Switch Module 37
Ω Unbalanced Cable Pinout 39
6. AT-A-GLANCE SPECIFICATIONS 40
Encryption Type 41
NETWORK TURNUP PROCEDURE 43
1. INTRODUCTION 44
2. TOOLS REQUIRED 44
Contents of Shipment 44
4. CHANNEL SELECTION 46
5. GROUNDING INSTRUCTIONS 47
7. MOUNTING OPTIONS 48
TRACER 6420 49
8. INSTALLING MODULES 50
Ω) Module Interfaces 51
USER INTERFACE GUIDE 53
Terminal Menu Window 55
Moving Through the Menus 56
2. MENU AND SYSTEM CONTROL 56
Password Protection 56
3. MENU DESCRIPTIONS 57
> SYSTEM STATUS 57
> MAIN MENU 59
> SYSTEM CONFIGURATION 60
> RF LINK CONFIGURATION 63
Channel A 64
Channel B 64
> RF LINK ERROR HISTORY 66
> DATAPATH PROVISIONING 69
A through D) 70
> E1X PERFORMANCE HISTORY 73
> T1X PERFORMANCE HISTORY 77
1 through 4) 78
> ETHERNET SWITCH STATUS 79
RX PACKET 80
MGMT Ethernet interface 82
Figure 32. Ping Utility 82
PING ADDRESS field. The 83
DEFAULT VALUES) 83
OCAL MGMT PORT 84
EMOTE MGMT PORT 84
OCAL IDU 85
EMOTE IDU 85
ENABLED by default 86
> SYSTEM ALARMS 87
YSTEM ALARMS > TEMP ALARMS 88
DETAIL LEVEL PROCEDURES 89
Prerequisite Procedures 91
ANAGEMENT/UTILITIES 96
100 612806420L1-1F 100
3. Telnet to the TRACER 64x0 101
102 612806420L1-1F 102
Introduction 103
Tools and Materials Required 103
CONTENTS 109
2. MIB COMPILATION ORDER 110
TROUBLESHOOTING GUIDE 125
X POWER “fuel gauge” on 130

Komentáře k této Příručce

Žádné komentáře

ADTRAN TRACER 6000 SERIES Průvodce řešením problémů Strana 97

Komentáře k této Příručce

Související produkty a manuály pro Sítě ADTRAN TRACER 6000 SERIES