ADTRAN Quad T1 IMA Instalační příručka Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
Physical Description NetVanta 6310/6330 Series Hardware Installation Guide
18 Copyright © 2013 ADTRAN, Inc. 61700100G1-34F
NetVanta 6330 Series Front Panel Design
The NetVanta 6330 front panel is shown below. Table 1 on page 19 describes all of the LEDs.
NetVanta 6330 Front Panel Features
Status LEDs
The status LEDs are located on the lower left side of the unit. The STAT LED indicates the unit’s
status. The
FXO LED reflects the status of the FXO interfaces. The FXS LED reflects the status of the
FXS interfaces. The
SLOT 1 LED reflects the status of a NIM2/VIM2 installed in NIM2/VIM2 option
SLOT 1 (located on the rear panel). The LAN 1 and LAN 2 LEDs reflect the status of the local area
networks (LANs).
CompactFlash Slot
The CompactFlash slot supplies nonvolatile configuration and compressed code storage. CompactFlash
densities from 64 to 1024 MB are supported.
Figure 3. NetVanta 6330 Series Front Panel Layout
NetVanta 6330 Rear Panel Design
The NetVanta 6330 rear panel is shown below.
Figure 4. NetVanta 6330 Series Rear Panel Layout
NetVanta 6330 Rear Panel Interfaces
VOICE Connector
A single 50-pin female amphenol connector labeled VOICE provides the interconnect wiring for up to
24 analog ports. See Table A-5 on page 44 for the
VOICE connector pinouts.
NIM2/VIM2 Option Slot
The NIM2/VIM2 option slot (labeled SLOT 1) accepts a variety of NIM2/VIM2 option modules (refer
to Option Modules on page 23).
FXO Ports
The two FXO interfaces (labeled FXO 0/1 and 0/2) provide FXO connectivity. See Table A-4 on page
44 for the FXO connector pinouts.
STATUS
FXO
FXS
SLOT 1
LAN 1
LAN 2
NetVanta 6330
CompactFlash
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Komentáře k této Příručce

Žádné komentáře