ADTRAN Express 3110 Manuál s instrukcemi stáhnout pdf (Strana 95)

Appendix C. Status Buffer Messages

61200239L1-20 Express 3010/3110 User Manual C-7

ID = XXXX

Calling party number.

INCOMING_CALL_BARRED

The network will not allow an incoming call.

INCOMPATIBLE_DEST

The called number cannot accept the type of call that has been placed.

INTERWORKING_UNSPEC

A non-ISDN network sent an unspecified message.

Inv Password

Remote configuration failed due to incorrect password.

INVALID_CALL_REF

Call control error.

INVALID_ELEM_CONTENTS

Call control error.

INVALID_MSG_UNSPEC

Invalid message: protocol error.

INVALID_NUMBER_FORMAT

The dialed number has an invalid format.

L1 not up

The network interface is not active.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 115 116

Express 3010/3110 1
5993 Avenida Encinas 2
Carlsbad, CA 2
Trademarks: 2
Table of Contents 15
List of Figures and Tables 19
Overview 21
For a PC 22
For a Macintosh 22
Basic Rate ISDN Line 22
Chapter 1. Overview 23
Table 1-1 25
Installation 27
Verify Switch Settings 28
Hardware Installation 29
BASIC TELEPHONE SERVICE 31
Supplementary Voice Services 31
Phone Number Allocation 32
(Express 3010 Only) 32
VT 100 TERMINAL EMULATION 33
VT 100 Configuration 34
VT 100 Terminal Status Buffer 35
Chapter 2. Installation 36
Application Configuration 37
Switch Protocol 38
Call Type 38
Service Profile ID (SPID) 39
Auto Answer 40
Call Screening 40
Call Routing 41
Dial Options 42
Redial last number 43
Answer call 43
Dial stored number 43
Store/Review number 43
OPTIONS FOR BOTH LEASED AND 44
SWITCHED ISDN SERVICE 44
DTE Options 44
Bit Rate 44
DTR Options 45
SETTING PROTOCOL OPTIONS 46
Setting PPP Mode 47
Clear Channel 47
BONDING Mode 1 48
FALLBACK 48
PPP and STAC Compression 49
FILES (QUICK SETUP) 50
IN-BAND DIALING 59
THE STATUS BUFFER 61
TEST OPTIONS 61
Protocol 62
Upgrading Software 63
Chapter 4. Upgrading Software 64
Installing an Analog Modem 65
Troubleshooting 67
Dial-Up Connection Problems 68
Express Not Detected 69
Dial-Up Networking Difficulty 70
AT Commands and S-Registers 71
Using an AT Command 72
Using S-Registers 72
Reading an S-Register 72
Reading an S-Register String 72
Changing an S-Register 72
Changing a String S-Register 73
CD forced on 74
S-REGISTER LIST 79
S-REGISTER STRING LIST 86
Appendix B 87
Appendix B. LEDs 88
Status Buffer Messages 89
Loop Status Messages 103
Connector Pinouts 107
Pin 4 Ring 108
Pin 5 Tip 108
Returning the unit to ADTRAN 115

Komentáře k této Příručce

Žádné komentáře

ADTRAN Express 3110 Manuál s instrukcemi Strana 95

Komentáře k této Příručce

Související produkty a manuály pro Sítě ADTRAN Express 3110